19
MAINTENANCE
WARNING!
ALWAYS DISCONNECT THE SAW FROM POWER SOURCE BEFORE CHANGING BLADES
,
CLEARING CHIPS OR MAKING ADJUSTMENTS
.
CHANGING SAW BLADES
Refer to the diagram below.
Chip Collector Cover
1. Place saw on a level, secure surface.
2. Remove chip collector cover (item #3) by loosening the
chip cover retaining screws. (Item 22)
3. Engage spindle lock (item# 40).
4. Using supplied wrench, loosen and remove
blade drive mounting bolt, washer and outer
blade drive flange (item# 8, 9 and 10).
5. Remove saw blade. (item 11)
6. Thoroughly clean inner and outer blade drive
flanges and blade mounting surface before
installing new blade.
7. Reverse process to install new blade.
Chip Cover Retaining
Thumb-Screws
REPLACING MOTOR BRUSHES
Refer to the diagram to the right.
1. Place saw on level, secure surface.
2. Remove two (2) motor brush retainer screws
(item# 1) and slide the brushes out.
3. If the carbon rod is less than 6mm or if there are signs
of burning or other wear, replace the brushes.
4. Reverse the process to re-assemble saw.
Brush Retainer
Screws
Blade Wrench
Blade Drive Mounting Bolt
Outer Blade Drive Flange
Saw Blade
