ABM-28
ABM-
28 Operator’s Manual
14
3.4. Replacing the cutting inserts
The inserts may be replaced or rotated. To do this, unplug the power cord from the
power
source
and
unplug the cable connecting the milling unit to the carriage. Next,
loosen the bevel depth lock lever (
1
, Fig. 7), set the lever
2
in the position shown in
the figure, and then remove the milling unit (
3
).
Fig. 7.
Removing the milling unit
Next, unscrew the set screw in the manner shown in Fig. 8, remove the insert,
and clean the socket. Next, rotate the insert by 90° and install again or replace with
a new one if all four edges are worn, securing with the set screw.
Fig. 8.
Replacing the cutting inserts
1
3
2
