ABM-28
ABM-
28 Operator’s Manual
11
3.2. Setting the bevel parameters
Loosen the lever
1
(Fig. 5), rotate the lever
2
to set a proper milling head penetration
in the workpiece indicated on the scale
3
(one graduation equals 1 mm
, 0.04’’), and
then lock the position using the lever
1
.
Fig. 5.
View of the milling unit
Next, loosen the levers
4
and
5
, rotate the milling unit in such a way to set
a proper bevel angle on the scale
6
, and then lock the levers
4
and
5
.
Start beveling with the milling head retracted as far as possible, especially when
milling at the angle of 0°.
Proceed with caution if
the
milling
unit
is
inclined
at
a
high
negative
angle. In such
a case when readjusting the milling head penetration near the maximal retraction,
hold the handles tightly not to allow the milling unit to slip down from the support after
the bevel depth lock lever
1
is unlocked.
1
3
2
6
5
4
