ABM-28
ABM-
28 Operator’s Manual
10
If the plate is to be machined at a negative angle (from the bottom), loosen two
milling unit support screws using the 4 mm hex wrench and set the indicator to the
value of the plate thickness (
9
). Position the milling unit support on the screws (
10
),
in the shown order place the washers under the nuts (
11
), and tighten the nuts using
the 13 mm flat wrench.
Set
the
lever
1
in
the position as in Fig. 4, insert the milling unit horizontally into
the support (
2
), and lock the bevel depth lock lever (
3
). If the plate is to be machined
at a positive angle (from the top), set the chip container on the brackets (
4
).
Fig. 4.
Installing the milling unit
2
3
4
1
