Page 6 of 18
939501051 Rev G
Remove front and rear aprons (Items 20 and 25) from one of the pedestal drawers. Next insert
tab on front apron(Item 25) into slot on rear apron (Item 20). Now align front and rear mounting
holes with pre-drilled holes in bottom of worksurface. Next secure aprons to worksurface with
(4) screws (Item 7). Refer to Fig. J.
NOTE: Install screw when
attaching apron to a cantilevered
support or end panel. Remove
knock-out in apron.
KNOCK-OUT
SLOT
TAB
Fig J
7
20
25
Fig K
Note: Use holes in support (Item 5)
as a template to drill (2) 1/8" Dia.
holes 3/4" deep into bottom of work
surface (Item 6)
7
3
6
5
1
9
2
4
11
5.
Installation of front and rear aprons
with 19" deep pedestal. A RH.i
nstallation is shown, LH. is typical.
6.
Place work surface (item 6) onto
support assemblies (items 1, 2, 3,
4 and 5) and secure with (8) screws
(item 7) and necessary screws
(item 11). Refer to Fig. K.6.
