Page 11 of 18
939501051 Rev G
27
Fig U
Fig V
29
NOTE: Position and stick caution label onto kneespace
side of pedestal below wire access.
3.
Insert hex head screw (item 27)
into 7/32" dia. hole drilled in step 2
of this section. This screw has a
hole thru its shaft. the screw must
be turned in so the bottom of
screw head is within 1/4" of the
worksurface. Refer to fig. U.
4.
Thread cable (item 29) down thru
the outside slot in top rear corner
of pedestal shown in fig. V. Next
place pedestal (item 28) upside
down onto worksurface (item 6)
and align pedestal attaching holes
with 1/8" dia. holes drilled in step
2 on page 12. Pedestal must be
flush at the back and side edge of
worksurface with (4) screws
(item 7) and (4) washers (item 30).
Refer to fig. W.
