7
Installation Of Power Chin Boom Unit
10.0
Power Chin Boom Arm Installation
10.2
Make sure the Power Chin Boom Motor Unit is properly installed before starting
installation of the Power Chin Boom Arm. The Motor Unit contains 2.5mm set screws.
CAUTION
Any connection must always be secured with all delivered screws. Only use the screws
provided in the package.
To install the arm, proceed as follows according to your installation plan:
Insert the Power Chin Boom T-Bar Connection into the motor unit. Adjust and secure
with provided set screws.
Attach the T-connection to the T-Bar Connection. Attach and secure with
provided set screws.
Insert the Power Chin Boom Right or Left Arm into the T-connection. Adjust arm to
desired length and secure with set screws.
Place and secure Arm to Rod Interconnection Assembly at the end of the arm.
Place C-Rod or S-Rod into end of the Arm to Rod Interconnection Assembly. Adjust angle
and secure with provided screw. Choose the rod that best fits your clients needs.
CAUTION
Select the appropriate screw location in the T-connection. Screws should be placed in
such a way that they do not enter the cable throughputs in the arm.
NOTICE
If needed, cut off excessive piping at the back of the arm (behind the T-connection).
Remember to keep a small excess of piping off the back in order to make readjustments.
SAFETY
By removing excess piping, this can reduce the risk of objects becoming hung or stuck.
This will also ensure safety during transfers.
NOTICE
There is play in the arm when it is not in the end position.
NOTICE
The screws on the Power Chin Boom need to be tightened regularly.
Summary of Contents for IDM-PCB-L
Page 46: ...a Notes 20 0 ...
Page 47: ...b Notes 20 0 ...