stayer TD355W, Operating Instructions Manual

Page: 13 / 20

There are certain applications for which
31.
t h i s t o o l w a s d e s i g n e d . T h e
manufacturer strongly recommends
that this tool NOT be modified and/or
used for any application other than for
which it was designed. If you have any
questions relative to its application DO
NOT use the tool until you have written
th e manu fac ture r and h ave b een
advised.
Metal chips are often very sharp and hot.
Never touch them with bare hands. Clean
up with a magnetic chip collector or other
appropriate tool.
T h i s m a c h i n e i s a D r y - C u t M e t a l S a w
designed to cut various ferrous and non-
ferrous metals. This saw uses blades that are
rat ed for 14 00 /min or h igher . I t is not
recommended to cut hardened steel as this
will drastically shorten the life of the blade.
Soft materials such as wood are also not
recommended.
UNPACKING
Carefully remove the tool and all loose items
from the shipping container.
Retain all packing materials until after you
have inspected and satisfactorily operated
the machine.
N O T E : A n a p p r o p r i a t e b l a d e m u s t b e
mounted to the machine before operating.
R e f e r t o t h e s e c t i o n o f t h i s m a n u a l :
“INSTALLING THE BLADE”
CARTON CONTENTS
1. Metal Cutting Saw
DO NOT OPERATE THIS TOOL UNTIL YOU READ
AND UNDERSTAND THE ENTIRE INSTRUCTION
MANUAL.
■
INSTALLING THE BLADE -DISCONNECT TOOL
FROM POWER SOURCE.
NOTE: Use blades that have an arbor bore
which can fit, and that are rated for 1114/
min or higher.
WARNING: Avoid contact with blade teeth to
prevent personal injury.
Ensure that the motor head is in its fully
1.
r a i s e d a n d l o c k e d p o s i t i o n a n d
unplugged. Remove the four screws
which hold on the outer blade cover
and remove the cover.
Orient the inner flange so that the
2.
correct side faces outwards.
Wearing thick work gloves to protect
3.
the hands, carefully hold the blade
from the top and lower it downwards
into position on the inner flange. It must
first slip into place in the lower guards
and then onto the arbor. Make sure
that the teeth point forwards. (If in
doubt of the orientation of the blade,
refer to the legend stamped into the
outer blade cover).
Position the outer blade flange with the
4.
convex side outwards, then the flat
washer and finally the arbor bolt.
Use the supplied 8mm hex wrench on
5.
the arbor bolt. Push in the arbor lock
(See Fig.2.) and rotate the arbor with
the wrench until the lock engages the
blade arbor.
O n c e t h e a r b o r l o c k i s e n g a g e d ,
6.
t i g h t e n t h e a r b o r b o l t b y t u r n i n g
clockwise.
Finally replace the outer blade cover
7.
and tighten the 4 screws. See Fig.3.
Fig.2
Arbor Lock
ENGLISH
10
10