stayer TD355W, Operating Instructions Manual

Page: 11 / 20

SPECIFIC SAFETY RULES
Always Secure the workpiece properly
1.
with the vise. Never hold the workpiece
by hand or attempt freehand cuts.
When clamping with the fence in a left-
2.
hand miter (clockwise) The clamp must
b e a u g m e n t e d w i t h a C - c l a m p .
Otherwise the workpiece will not be
securely held.
Never Attempt to adjust, open or close
3.
the vise while the blade is in motion.
K e e p h a n d s a n d b o d y a w a y f r o m
4.
cutting area and rotating blade. Never
reach around, under or across the
blade.
Check lower guard for proper closing
5.
before each use. Do not operate the
saw if lower guard does not move freely
and close instantly.
Never clamp or tie the lower guard into
6.
the open position.
Check the operation and condition of
7.
the lower guard. If the guard is not
operating properly, it must be serviced
before use. Lower guard may operate
s lu gg is hl y d ue to da ma ge d pa rt s,
gu mmy deposits, or a buildup of debris.
Do not use abrasive wheels with this
8.
machine. This machine was specifically
designed to use carbide tipped metal
cutting blades.
Always use blades with correct size and
9.
shape arbor holes. Blades that do not
match the mounting hardware of the
saw will run eccentrically, causing loss
of control.
Never use damaged or incorrect arbor
10.
flanges or bolts. The arbor flanges and
bolt were specially designed for your
saw, for best performance and safety of
operation
Always check the maximum rated
11.
speed of the balde and ensure that it
exceeds the speed of the machine
(1300/min).
Do not use damaged or dull blades.
12.
Kickback may result.
Take care to avoid twisting or binding
13.
the blade. The blade will be damaged.
Hold tool by insulated gripping surfaces
14.
when performing an operation where
the cutting tools may contact hidden
wiring or its own cord. Contact with a
“live” wire will make exposed metal
parts of the tool “ live ” and shock the
operator.
KICKBACK:
If the blade becomes twisted or misaligned
in the cut, the teeth at the back edge of the
blade can dig into the top surface of the
workpiece, causing the blade to climb out
of the kerf and jump back toward the
operator and/or eject the workpiece from
the machine at high speed. Kickback is the
r e s u l t o f t o o l m i s u s e a n d / o r i n c o r r e c t
operating procedures or conditions and can
be avoided by taking proper precautions as
given below:
Maintain a firm grip on the saw and A.
position your body and arm in a way
that allows you to resist KICKBACK
forces . KICKBACK forces can be
controlled by the operator, if proper
precautions are taken.
ENGLISH
8
8
01.Carriage Lock
02. Wrench storage
03. Motor
04. Depth Stop & Lock Nut
05. Tool-Free Fence Lock
06. Fence with scale swivels 45
degrees
in both directions
07. Vise Plate
08. Transport Lock Chain
09. Crank
10. Vise Release Lever
11. Two-piece Lower Blade Guard
12. Hook (for Transport Lock Chain)
13. See-Through Shield
14. Arbor Lock
15. On / Off Switch