i95 LUX, i95, i95 ECO
Device registration
In order to register new components, the immobilizer needs to be
switched to the device registration mode. If using an i95 LUX
immobilizer, switching is done using the indication module. For i95
and i95 ECO immobilizers it is done using the ignition key.
In order to prevent the unauthorized registration of
labels, the unlock code (shown on the plastic card) is
needed to enter the device registration mode. If you told
the
unlock code
to the installation specialist, change it
after the device registration procedure is finished.
CAUTION!
The cipher codes’ exchange during the
registration is executed via a radio link
in a plain form
.
We recommend performing the registration procedure
while the vehicle is located outdoors and at a fair
distance from any locations where the signal could
possibly be intercepted.
Switching to the programing mode from the service
mode is impossible (yellow light).
Entering the device registration mode on i95 LUX
Using the
unlock code
, switch the system to the parameter
programing mode (see page 42). Then, perform the following
actions:
1) Quickly press the indication module button. The LED will begin
flashing in yellow.
2) Within the next 2 minutes press the indication module button
and hold it for over 3 seconds, until the LED blinks off. Release
the button.
48