Starcraft STARFLYER 2015, User Manual

Page: 82 / 152

SECTION 4 – TOWING & SET-UP STARCRAFT TOWABLE
4-32 SCT
Initial Installation

NOTE: The initial installation of the canopy should be performed by an
authorized service technician. Read all instructions prior to installing.
Canopy Set-up

NOTE: It will be easier to set up the canopy if you don’t raise the roof of the
unit until canopy set up is complete.
1. Unzip the canopy bag.
2. Hold on to the canopy and undo the Velcro retaining straps.
3. Unroll the canopy until the main rail is exposed.
4. Release the canopy legs from the main rail. Move the foot at the
end of the canopy leg so it will be flat when placed on the ground
(Fig 4a). Place your foot on the foot of the canopy leg and pull up
until the leg locks into place. Set the canopy legs on the ground
in the upright position. NOTE: If your canopy has a center
post, insert the post into the hole in the center of the main rail.
5. Pull out the telescoping side arms. Pull the canopy flaps over the front and
side rails and at the corners. NOTE: tilting the vertical legs in slightly will
make it easier to pull the flaps down at the corners. Secure the end of the
side arm into the top holder on the side of the unit (Fig. 5a), making sure the
side arm snap buttons lock into place (Fig 5b). The side arm(s) should be
extended so the canopy fabric is tight, but not tight enough to pull or stretch
the fabric. If the side arms start to bow as you raise the unit, STOP
IMMEDIATELY and adjust the canopy.
CAUTION
The canopy should be set-up using two people. Failure to do so can result in
damage to the canopy or injury. Make sure to hold rolled canopy when bag
is unzipped to keep it from falling.
Fig. 5a
Fig. 5b
Fig. 4a
CAUTION
Over tightening the canopy may result in excessive wear or tearing of the
fabric at seams, at corners or where the canopy is attached to the unit.
Fig. 5a