4
▲
button
▼
button
display screen
“MERGE” button
“REVERSE” button
“DARKER/LIGHTER” button
DAILY OPERATION
CERTAIN SURFACES ARE EXTREMELY HOT DURING
OPERATION AND CARE SHOULD BE TAKEN WHILE
USING THIS UNIT.
DO NOT LEAVE THE UNIT IN OPERATION WITHOUT
AN ATTENDANT.
DO NOT LEAVE THE UNIT AT HIGH TEMPERATURE
WHEN NOT IN USE OR DURING IDLE PERIODS.
START UP / PREHEAT
i.
When the toaster has been plugged into a suitable
outlet and power supply, the power switch can be
flipped up to turn the unit on.
ii.
The toaster will enter into its
PREHEAT
mode and
a 15-minute countdown timer will appear on the
screen. The fans and conveyors will turn on and the
radiant elements will begin to heat up.
iii.
The unit will, by default, use the conveyor speed
and heater setting last used before the previous
shutdown.
MAIN MENU
i. DISPLAY
—Once the toaster has been pre-heated,
menu products will appear in two lists on the display
separated into a left and right side. The left conveyor
and heaters are controlled
by the left side buttons
and the right side is
controlled by the right
side buttons.
ii.
▲
/
▼
ARROWS
—The selected preset can be changed
simply by pressing the
▲ or ▼
on the corresponding
side until the desired preset is highlighted. The heat
and speed setting change will occur instantly. Actual
temperature changes in the heaters may require
several minutes to adjust to the desired level.
iii. MERGE
—The “MERGE” buttons will cause the speed
and heat settings of the two conveyors to be the same
as the setting of the side that was pressed. For example,
if the left “MERGE” button is pressed, the right conveyor
will change its preset to match the left side's preset.
Selecting another preset will return the toaster to split
operation.
iv. REVERSE/MELT
—The “REVERSE” button causes the
conveyor to stop and the word “MELT” to flash on the
screen. When the programmed amount of time has
elapsed, the conveyor(s) will reverse for several seconds
and then stop. The conveyor(s) will remain stopped until
the “REVERSE” button is pressed again or the preset
product is changed using the
▲
or
▼
buttons.
v. DARKER/LIGHTER
—The “DARKER/LIGHTER” button
can be pressed once to activate a conveyor speed
adjustment mode from the main menu. After the
button is pressed, the words “DARK” and “LIGHT”
at the bottom of the display will turn bright yellow
indicating the function is active. The up and down
arrows will cause the belt to slow down or speed up
on the corresponding side allowing quick adjustments
in toasting color. Selecting “LIGHT” will increase
conveyor speed, while selecting “DARK” will decrease
conveyor speed. Adjustments made here will stay the
same until preset is changed or the unit is turned off.
SHUTDOWN
Disconnect power to the unit with the power button
at the end of each day of operation. The fans may
still continue to run until the toaster has completely
cooled.
If the toaster must be moved after using,
allow the cooling fan to turn off before unplugging
.
PRE-HEATING
13 : 20
RIGHT
LEFT
LIGHT DARK LIGHT DARK
MUFFIN
FLATBREAD
CROISSANT
BAGEL
CROISSANT
MUFFIN
