STAR
TRAC
S
SERIES
TREADMILLS
O
WNER
’
S
M
ANUAL
49
T
ROUBLESHOOTING
STAR TRAC S SERIES TREADMILLS
perform a self-test at the beginning of every workout. If a problem is detected, a
message displays before or after the workout, depending on the nature of the problem. Star Trac recommends that you refer
your questions about your
STAR TRAC S SERIES TREADMILL
operation and suspected malfunctions to Star Trac’s
Service Hotline at (800) 503-1221, or USA 1-714-669-1660.
START-UP SERVICE MESSAGES
The following messages are displayed at the beginning of a workout if the associated problem is detected during self-test.
NO STOP
- This error generally occurs when the Stop Switch is not connected tightly to the circuit board of the Display
Control Panel. It may also happen if the circuitry associated with the switch develops a fault. When you see
NO STOP
:
•
Set the
ON/OFF
switch to
OFF
; wait 2 seconds.
•
Set the
ON/OFF
switch to
ON
. Notify Star Trac if additional assistance is needed.
KEY DOWN
- This error generally occurs when a key is held pressed while the
ON/OFF
switch is moved to
ON
. It may also
happen if a key becomes stuck. When you see
KEY DOWN
:
•
Set the
ON/OFF
switch to
OFF
; wait 2 seconds.
•
Set the
ON/OFF
switch to
ON
. The treadmill should be operational again. Notify Star Trac if additional assistance is
needed.
SPEED CHANGE:
This error generally occur when the running belt speed sensor is disconnected, faulty, or misaligned
relative to the revolutions-per-minute (RPM) sensor of the motor. It may also occur if the speed sensor cable is damaged, or if
the Motor Control Board (MCB) is misadjusted or faulty. When you see
SPEED CHANGE
:
•
Set the
ON/OFF
switch to
OFF
; wait 2 seconds.
•
Set the
ON/OFF
switch to
ON
. Notify Star Trac if additional assistance is needed.
ELEVATION STALL
,
ELEVATION RANGE
OR
ELEVATION LOST:
These errors generally occur when the elevation
(incline) potentiometer is faulty or out of limits, or the elevation motor is disconnected or receiving low power. They may also
occur if the Motor Control Board (MCB) is faulty or the motor gears are stripped. They are usually accompanied by failure of
the treadmill to rise from an elevation other than maximum (or descend from an elevation other than minimum), with
attendant beep indication, when (or ) is pressed. When you see
ELEVATION STALL
,
ELEVATION RANGE
OR
ELEVATION LOST
:
•
Notify Star Trac for diagnosis and disposition.
