CrossTrainer Service Manual
25
CrossTrainer Service Manual Rev A 620-7575
Part Inst. Procedure - LCB, Batt. And UB Board (cont.)
Battery Replacement
Remove the Old Battery
1. Use the Phillips head screwdriver to remove the 4 screws holding the
battery to the frame.
2. Unplug the wires from the battery and set the old battery aside.
Install the New Battery
1. Before installing the new battery, use a multi-meter to check the voltage.
x
New
unused batteries should be 6.3 volts or above.
x
A battery with a marginal charge will be between 6.0 and 6.2 volts.
x
If the battery is less than 6.0 volts, do not install. Obtain a new battery.
2. Plug the wires into the new battery.
x
Red wire plugs into the positive (+) of the battery
x
Black wire plugs into the negative (-) of the battery.
Note: Incorrect wiring of the battery may cause damage to the system.
Upper Body Electronic Board Replacement (Elite Only)
Remove the Old UB Board
Note: Accessing the UB Board is easier if you remove the left shroud panel.
1. Unplug the 2 wires from the UB board.
2. Use the short Phillips head screwdriver to remove the 2 screws holding the UB board to the
frame.
