D-F0390 NP-326 Product specifications Ver.0.02
17
4.2 Processing error
1) Error detection details
Name Status
BUSY
PE
/ERR
OR
232C
status
PL
status
Removal
Comm.
error
232C Comm. error
Parity
Overrun
Flaming
Data “?” print
-
-
-
-
-
Align comm.
condition
Paper near
empty
Paper remain sense
CN7 sensor
L H H 0bit
1
-
Load paper
Head up
Head up
L L L 1bit
1
On
Head up lever
down
Paper end
No paper
L
H
L
2bit 1
On
Load paper
Head temp
high
Over 80
°
C
L L L 3bit
1
Flash
Return normal
with 60
°
C
Cutter error
Cutter jam
L H L 4bit
1
Flash
Remove jam and
Turn on again
Eject sensor
information
Paper at the exit
sensor
L L H 6bit
1
-
Remove paper
When the above errors are detected except transmission error and paper low end error, printer
stops all operations and outputs error signal.
In the case of serial interface:
Error bit in the status information is set to “ON”.
2) Return to normal status from error statuses
Remove causes of error statuses and turn the power on again to return to normal. When
this process is activated, at the time of power switch turned off, the printer will be initialized,
so that settings are required again.
If data remains in the buffer, attention should be paid
4.3 Buffer full print
If there remains data in the buffer after one line of data is received, printer automatically prints
preceding data. The volume of buffer full data varies depending on ASCII characters or bit
images.
