D-F0390 NP-326 Product specifications Ver.0.02
5
2.2 Printing area and cut position
Partial cut remaining tab: aprox. 2 mm
Cut Position
Cutter to Head
Approx.13±1.0mm
1dot
2dots
A dots
(Note1)
Feed direction
0.125mm
0.125mm
B ±0.2mm
(Note2)
C ± 1.0mm
4.0±1.0mm
Approx. 3 mm feed will
took place by the
D
mm firmware, so the margin
will be 16±1mm.
Note2: Please take care not to take the paper very hard after the partial cut, which cause heavy load on
platen and might cause the poor print quality on the head part of next line. To avoid such problem,
please take care by feeding approx. 1 mm at the beginning of print or by take the paper to the direction
to left or right.
Note3: The cut mode (full cut or partial cut) is set by the factory. No change of cut mode is done by the
command setting.
A
B
C
D
NP-226 432 54
2 58
NP-326 576 72
4 80
0
-1
