-7-
CONTROL HEAD
The control head is designed to be flush mounted. Select a location such as the
dash, the overhead console, or a center console. Choose a mounting location
convenient to the operator and away from any air bag deployment areas. Be sure
to choose a location that has at least two inches of depth to accommodate the
control head and cables. Consider wire routing and access to connections when
selecting location as well.
Mark the mounting hole locations and the area to be cut out using the control head
installation template provided on page 19. CAUTION: Use extreme caution not to
oversize the cutout area. The control head will only overlap this cutout hole by 1/8"
on the top and the bottom. Temporarily place the control head in the cutout
opening to verify the alignment of the unit. Remove the control head and connect
the communication cable and the two power cables. If the option jumpers on the
back of the control head have not been previously set, refer to the Installer
Selectable Options section on pages 3-6. Permanently mount the control using four
#6 screws (not provided).
MICROPHONE BRACKET
A metal clip is provided for mounting the
microphone. Choose a location convenient to
the operator and away from any air bag
deployment areas. Using the mounting clip as a
template, mark the two holes to be drilled. Using
a 1/8" drill bit, drill the two mounting holes. Install
the two #6 screws provided with the bracket.
(Mounting CONT’D)
