-6-
Mounting
Horn Ring Transfer
The installer may opt to have the sirens electronic air horn replace the vehicle horn.
This can be done by adding a single pole, double throw (SPDT) switch. Two Horn
Ring Transfer wiring diagrams are shown below.
SAFETY PRECAUTIONS
For the safety of the installer, vehicle operator, passengers and the community
please observe the following safety precautions. Failure to follow all safety
precautions and instructions may result in property damage, injury or death.
!!! WARNING !!!
DO NOT mount in air bag deployment area.
Devices should be mounted only in locations listed in SAE standard J1849.
Controls should be placed within convenient reach of the driver.
Assure clearances before drilling in vehicle.
Sound levels produced by attached speakers can cause permanent hearing loss.
Never operate this unit without adequate hearing protection for you and others.
in the area. (OSHA 1910.95)
AMPLIFIER
The amplifier should be mounted in a location such
as the driver compartment firewall, under the seat, or
in the trunk. It is not recommended to mount the
amplifier in the engine compartment or in an area
that would be allowed direct exposure to weather
elements. Choose a mounting location away from
any air bag deployment areas. Assure adequate
ventilation to prevent overheating
The amplifier unit is provided with a mounting flange that contains four 1/4" holes.
Using the amplifier unit itself as a template, mark the location of the four mounting
holes to be drilled. Be sure to check for obstructions behind the mounting hole
locations. Drill the four mounting holes and secure the amplifier using appropriate
hardware (not supplied). Be sure that all wiring harness connections are made prior
to connecting the harness to the amplifier unit.
(Installer Selectable Options CONT’D)
