-2-
1.
IMPORTANT:
Please read all of the following instructions before installing your new
warning light.
2.
CAUTION:
All of our DC powered warning lights are polarity sensitive. These lights are
polarity protected
only if the appropriate fuse
is used. All wires connected to the positive
terminal of the battery should be fused at the battery for their rated load.
Testing the
light before this fuse is properly installed will void the warranty on the light.
3. Permanent mount lights are mounted using four bolts that screw into molly well nuts in
each corner of the minibar. Mark the four mounting holes (and the center wire hole, if
you will be needing one). Mark the holes on the corners of a 14-1/2” x 5-1/2” rectangle.
4. Check the underside of the marked locations to ensure that you do not damage any
wires or other components. Drill a 3/16”" hole in the four marked spots for the mounting
bolts, and one in the center for your wires (if applicable).
CAUTION: Take care not to drill through the headliner below.
5. If the 4 threaded molly well nuts are not already installed in
the base of your bar, install them by pressing one into each
of the four holes found on the corners of the base of the
light until the lip rests on the bottom surface of the base.
6. Route your wires through the center hole (if applicable) and attach the light using the
four enclosed bolts. Insert the bolts from below, through the holes you drilled in the
mounting surface and screw them into the molly well nuts on the light. Tighten until
snug.
Mounting Instructions
