-3-
White
-
(Synchronization)
Used to synchronize two lights together. If you are
only installing one unit, cut the White wire short and tape the end. If you
will be synchronizing two or more approved synchronizable lights,
leave
the white wire disconnected for now
. Connect the white wires from both
units together
ONLY AFTER PROGRAMMING
them for the
same
pattern (see Pattern Programming).
Red
-
(Power Color 2)
Connect to +12 VDC through your switch.
Be sure to
use a 10 amp fuse
when connecting the switch to the positive side of
the power supply.
Orange
-
(Power Color 1)
Connect to +12 VDC through your switch.
Be sure to
use a 10 amp fuse
when connecting the switch to the positive side of
the power supply.
Purple
-
(Optional - High/Low)
Used to switch the light between High and Low
power.
Leave disconnected for High Power only (cover with wirenut or
tape).
Connect to +12VDC for Low Power only.
Connect to +12VDC through a switch for High/Low switching option.
Red w/Green
-
(Pattern Select)
Touch and release to +12 VDC to change patterns.
Black
-
(Ground)
Connect to the negative side of the battery.
Electrical Connections
WHITE:
Synchronization (Optional)
- AFTER setting flash patterns
connect white wires from synchronized lights together.
Cut short and cap off if not synchronizing.
RED:
Power (Color 2)
ORANGE:
Power (Color 1)
PURPLE:
High/Low Power Select -
+12VDC for Low / Open for High
RED w/GREEN:
Pattern Select -
Touch and release to +12VDC
BLACK:
Good Chassis Ground
10A
FUSE
