-5-
Hold Patt. Sel. and Synch
Wires to +12VDC for
Unit Blinks
Priority Mode Shortcut
3 seconds
1 time
No Priority
6 seconds
2 times
Orange Priority
9 seconds
3 times
Red Priority
12 seconds
4 times
Toggles Sequential Mode
To change the Priority Mode, Proceed as follows:
1. Connect either the Red wire or the Orange wire to +12VDC and connect the black wire
to ground.
2. Hold
both
the Pattern Select wire (Red w/Green stripe) and the Synch wire (White) to
+12VDC, releasing them after the light flashes the corresponding number of times
indicated in the chart below.
NOTICE
Due to continuous product improvements, we must reserve the right to change any specifications and information,
contained in this manual at any time without notice. Star Headlight & Lantern Co., Inc. makes no warranty of
any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and
fitness for a particular purpose. Star Headlight & Lantern Co., Inc. shall not be liable for errors contained herein
or for incidental or consequential damages in connection with the furnishing, performance, or use of this manual.
(Programming CONT’D)
PRIORITY MODES
If both colors are activated (either by using both wires, or if you have set one wire for Dual-
Color Mode), the default setting is for both colors to flash their pattern, one after the other
(No Priority in Sequential Mode). There are 3 optional Priority settings:
Orange Priority
: If both wires are activated only the Orange wire functions.
Red Wire Priority
: If both wires are activated only the Red wire functions.
Sequential/Integrated Mode
:
► Sequential Mode:
(Default setting)
If both colors are activated the light
will run a full cycle (On then Off) of one of the colors and its
corresponding pattern, then run a full cycle of the other color
and its corresponding pattern.
► Integrated Mode: If both wires are activated the light will flash both colors
using the pattern of the Orange wire. For alternating
patterns, the colors will alternate halves back and forth with
one color flashing on one side of the light and the other color
flashing on the other side of the light at the same time. For
simultaneous patterns, the entire light will quickly flash the
pattern in one color, then the other color (similar to
Sequential mode, but no off time).
