33
Item
Description
Daily
Weekly
Monthly Quarterly Annually
Battery
Check the liquid level. Add distilled water if
necessary.
☑
Charge the battery.
☑
Tighten the nut on the battery cable.
☑
Check if the battery is over-discharged (the
battery power meter is flashing).
☑
Check the liquid density of the battery,
standard density should be 1.277±0.007g/
cm³ (80˚F or 25˚C) when the battery is fully
charged.
☑
Check if the battery is charged fully by a) using
the hydrometer, or b) checking the battery
power meter.
☑
Clean the surface of battery.
☑
Charger
Observe the charging status; check if the
charger plug becomes hot.
☑
Clean the surface of the charger. Do not get
any water inside the charger.
☑
Controller
Check that all terminals are tightened proper-
ly. Do this after the power is off.
☑
Clean the surface of the controller.
☑
Check that the solenoid is in order by check-
ing its touching point.
☑
Motor
Ensure that no water gets in and that it does
not become too hot.
☑
Check if the carbon brush should be replaced.
☑
Check that the accelerator pedal works well
and that it can be released freely and auto-
matically.
☑
Chassis
and body
Check if the brake drum and the brake shoe
should be replaced.
☑
Check that the hand brake functions (applica-
ble for vehicle with hand brake).
☑
Check if the hose and tube for the brake liquid
leak (hydraulic brake).
☑
Check if the brake liquid inside the brake
liquid tank is sufficient (hydraulic brake).
☑
Check the air pressure inside the tire, check
if the tire surface is worn, and check that the
nuts are tightened properly.
☑
Check if the shock absorber has any oil leak-
ing, or emits an abnormal noise.
☑
Check if there is oil leaking on the gear box
and the rear end.
☑
Add lubricant inside the wheel hub and
steering system.
☑
Adjust the toe-in of the front end.
☑
Clean the body and seat.
☑
