2. Use a jack to lift the vehicle, then remove the wheel nuts and the wheel.
To install a wheel on the vehicle:
1. Use a jack to lift the vehicle, then put the wheel onto the wheel hub.
2. Finger tighten the lug nuts, then tighten lug nuts to 50-85 ft.lbs.(70-115
Nm) in 20 ft.lbs.(30 Nm) increments following the ‘cross sequence’ pattern
3. Remove the jack.
If the tire is flat, remove the wheel and inflate the tire to the maximum recommend-
ed pressure for the tire. Immerse the tire in water to locate the leak and mark with
chalk. Place tire plug according to the manufacturer’s specifications.
Brake Adjustment
WARNING:
If you have any problem with the brakes, consult with a dealer. Brake
failure can result in serious accident or physical danger.
The brakes on the vehicle are self-adjusting. Before you operate the vehicle, press
down on the brake pedal several times to make sure the brakes are functioning
properly.
Lubrication
Use 1 liter of 90GL hypoid gear oil for the rear end. Lubrication points: a. Spindle
assembly (driver side and passenger side); b. Middle shaft; c. Rear end.
30
