STANNOL INDUSTA HF, Operating Instructions Manual

Page: 32 / 82

32
Operating instructiOns
STAND-BY moDe AND AUTomATIc SHUTDowN FUNcTIoN
The stand-by and automatic shutdown mode is activated by default
If the soldering iron is not in use for 20 minutes, the soldering station will be switch to stand-by
mode. The soldering iron power supply will be reduced, the temperature set to 200°C and display
will show flashing
---
.
If the soldering station is not in use for more than 40 minutes the soldering station will send into
hibernation mode, which automatically cuts off the power supply.
There are three ways to wake from standby:
1.
Turn off / on the soldering station.
2. Press any button on the soldering station.
3. Pick up the iron handle from the stand.
wake up from hibernation:
Turn off / on the soldering station.
TemperATUre correcTIoN
Whenever you replace a soldering iron a heating core or a tip the temperature of the soldering
iron should be recalibrated for precise temperature readings. For best results use a soldering iron
temperature tester.
● Set the soldering station to a certain temperature value.
● Wait until the temperature reading is stable and measure the temperature of the tip with a
soldering iron temperature tester or other appropriate thermal measurement device. Write
down the readings.