23
operATINg INSTrUcTIoNS
INTeNDeD USe
When used for its intended purpose, this device corresponds to the state of the art, as well as to the
current safety requirements at the time of its introduction. The appliance is designed to produce
solder joints with soft solder for electrical and electronic purpose.
Any other type of use is inappropriate. Improper use or modifications to the device or the use of
components that are not tested and approved by the manufacturer may result in unforeseen dama-
ge! Any use that deviates from its intended use and is not included in these instructions is conside-
red unauthorized use and relieves the manufacturer from his or her legal liability.
geNerAL SAFeTY INSTrUcTIoNS
●
To operate this device safely, the user must have read and understood these instructions
for use before using the device for the first time.
●
Observe all safety instructions! Failure to do so may cause harm to you and others.
●
Retain all instructions for use, and safety instructions for future reference.
●
If you sell or pass the device on, you must also hand over these operating instructions.
●
The device must only be used when it functions properly. If the product or part of the product
is defective, it must be taken out of operation and disposed of correctly.
●
Never use the device in a room where there is a danger of explosion or in the vicinity of flam-
mable liquids or gases.
Summary of Contents for INDUSTA HF
