Midilift SL
Installation Guide
October 2016
NOTE
: Ensure hose is routed clear
of the carriage and platform
underside to prevent damage when
the lift is at its lowest level
4
HYDRAULICS
Position the pump unit as per the builders work drawing.
Connect the hose to the pump unit and route hose to the base of the ram,
CONNECT TO RAM AT THIS STAGE
Run the cable from the pump unit to the cable
Electrically connect the pump unit to the 240v
supplied.
Fill pump with correct oil to level. Prime the hose with oil by fitting a s
fitting and running the pump for a few seconds, until clean air free oil fl
into a suitable container. Stop the pump and release the male quick release fitting. This will
minimize air in the hydraulic system.
Connect the quick release coupling to the base of the ram ensuring it is fully engaged. Any
excess hose should be loosely coiled around the motor (nominal
For 3 stage ram details see section 21
Version 9
Ensure hose is routed clear
of the carriage and platform
underside to prevent damage when
the lift is at its lowest level
Position the pump unit as per the builders work drawing.
Connect the hose to the pump unit and route hose to the base of the ram,
AT THIS STAGE!
Run the cable from the pump unit to the cable connector bracket.
connect the pump unit to the 240v ac power supply as per wiring manual
Fill pump with correct oil to level. Prime the hose with oil by fitting a spare male quick release
fitting and running the pump for a few seconds, until clean air free oil flows through the hose
into a suitable container. Stop the pump and release the male quick release fitting. This will
minimize air in the hydraulic system.
Connect the quick release coupling to the base of the ram ensuring it is fully engaged. Any
ose should be loosely coiled around the motor (nominal 80mm radius).
see section 21.
Quick release coupling
19
Connect the hose to the pump unit and route hose to the base of the ram,
DO NOT
ac power supply as per wiring manual
are male quick release
ows through the hose
into a suitable container. Stop the pump and release the male quick release fitting. This will
Connect the quick release coupling to the base of the ram ensuring it is fully engaged. Any
0mm radius).
Quick release coupling
