12
13
TO START A COLD ENGINE
Turn switch to “I” ON postion.
Slowly press the primer bulb 5-10 times.
NOTE: After the 7th press, fuel should be visible in
the primer bulb. If it is not, continue to press the
primer until you see fuel in the bulb.
Push the choke button in to set the choke to
FULL CHOKE position. NOTE: Do not squeeze the
throttle trigger because the choke will pop out
automatically.
Pull the starter grip /cord until resistance is
detected. Rapidly pull 3 to 5 times or until you
hear engine turn over or begin to start. (see Fig. 4)
If engine does not start, release choke by
squeezing throttle trigger and red choke button
pops out.
Engine is now in the run position.
Rapidly pull starter grip/cord until engine starts. (see Fig. 4)
Allow the engine to run for 10 seconds, then squeeze throttle to
provide fuel to engine and use for intended task.
Note: The choke button is only used when starting a cold
engine. Never push the choke button in once the engine
has been turned over or run. Otherwise the engine could be
damaged or not run due to FULL CHOKE.
STOPPING
The engine is switched off by moving the stop switch to the stop
position. (see Fig. 5)
OPERATION
Fig. 4
Fig. 5
