Stanley STGS7115, Manual

Page: 8 / 44

Package Content
This product package includes:
1 Angle grinder
1 Guard
1 Flange set
1 Spanner
1 Handle
1 Instruction manual
• Check t he tool, parts, and accessories to see if they are
damaged during transportation.
• Take a f ew moments to read and understand this
manual before using the tool.
Description (Fig. 1)
Warning: Never modify the power tool or any
part of the tool, otherwise it may cause damage
to the tool or result in personal injury.
a. ON/OFF switch
b. Spindle lock
c. Guard
Purpose of Design
This angle grinder is designed especially for grinding.
Do not use sandpaper discs and grinding wheels other than
those with depressed center.
Do not use the tool in wet conditions or environments in the
presence of flammable liquids or gases.
This heavy-duty angle grinder is a professional power tool.
Do not allow children to come in contact with this tool.
Inexperienced operators are required to use this tool under
supervision.
No-Volt
The No-volt function stops the grinder restarting without the
switch being cycled if there is a break in the power supply.
Electrical Equipment Safety
Only one voltage is applicable to this tool. Be sure to check
that the power suuply corresponds to the voltage on the
rating plate.
Your Stanley tool is equipped with double
insulation, hence, it does not require to be
earthed.
When the power cord is damaged, have it sent to a Stanley
service center for replacement to specially prepared cables.
Using Extension Cords
If an extension cord is required, please select a 3-phase
extension cord that has been inspected and matches the
input power (see Technical Data) of this tool. The minimum
conductor size is 1.5mm 2 , maximum length is 30 meters.
When using a cable reel, be sure to pull out all the cables.
Assembly and Adjustment
Warning: To minimize the danger of serious
personal injury, please switch off the tool
power and disconnect all plugs before adjusting or
removing/installing any accessory. Before reassembling
the tool, press and release the trigger switch to make sure
the tool is already switched off.
Attaching and Removing the Wheel Guard
(Fig. 2)
Warning: To minimize the danger of serious personal
injury, please switch off the tool power and disconnect
all plugs before adjusting or removing/installing any
accessory.
Before reassembling the tool, press and release
the trigger switch to make sure the tool is already switched
off.
8
ENGLISH
(Original instructions)