Stanley STDH6513C, Original Instructions Manual

Page: 7 / 20

USE
Warning! Let the tool work at its own pace. Do not
overload.
Warning! Before drilling into walls , floors or ceilings, check
for the location of wiring and pipes.
Selecting the direction of rotation (fig.E)
For drilling and for tightening screws, use forward
(clockwise) rotation. For loosening screws or removing a
jammed drill bit, use reverse (counter clockwise) rotation.
• To select forward rotation, push the forward/ reverse
button (3) to the left position.
• To select reverse rotation, push the forward /reverse
button to the right.
Warning! Never change the direction of rotation while the
motor is running.
Selecting the drilling mode
• For drilling in masonry, set the drilling mode selector (4)
to the position.
• For drilling in other materials and for screwdriving, set
the drilling mode selector to the 1 position.
Setting the drilling depth (fig.B)
• Slacken the side handle (7) by turning the grip counter
clockwise.
• Set the depth stop (6) to the desired position. The
maximum drilling depth is equal to the distance between
the tip of the drill bit and the front end of the depth stop.
• Tighten the side handle by turning the grip clockwise.
Switching on and off
• To switch the tool on, press the variable speed switch(1).
The tool speed depends on how far you press the
switch. As a general rule, use low speeds for large
diameter drill bits and high speeds for smaller diameter
drill bits.
• For continuous operation, press the lock-on button (2)
and release the variable speed switch. This option is
available only at full speed in both forward and reverse
modes.
• To switch the tool off, release the variable speed switch.
To switch the tool off when in continuous operation,
press the variable speed switch again and release it.
Maintenance
Your STANLEY power tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Important
To ensure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment ( other than those listed in this
manual) should be performed by authorized service centers
or other qualified organizations, always –using identical
replacement parts inside.
Cleaning
Warning! Blow dirt and dust out the main housing with dry
air as often as dirt is seen collecting in and around the air
vents. Wear approved eye protection and approved dust
mask when performing this procedure.
Warning! Never use solvents or other harsh chemicals for
cleaning the non – metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap. Never
let any liquid get inside the tool; never immerse any part of
the tool into a liquid.
Accessories
The performance of any power tool is dependent upon the
accessory used. STANLEY accessories are engineered to
high quality standards and are designed to enhance the
performance of power tool.
STANLEY offers a large selection of accessories available at
our local dealer or authorized service center at extra cost.
Caution: The use of any other accessory not
recommended for use with this tool could be hazardous.
Service Information
STANLEY offers a full network of company-owned and
authorized service locations throughout Europe. All
STANLEY Service Centers are staffed with trained
personnel to provide customers with efficient and reliable
power tool service. Whether you need technical advice,
repair , or genuine factory replacement parts, contact the
STANLEY location nearest to you.
7
ENGLISH
(Original instructions)