4
ENGLISH
Kerosene Foreced Air Heater (ST-80T-KFA/ST-140T-KFA/ST-215T-KFA)
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A POWER SOURCE
FEATURES
ASSEMBLY INSTRUCTIONS (140T-KFA / 215T-KFA)
Hot Air Outlet
Upper Shell
Handle
Extension Cord Wrap
Fan Guard
Pressure Gauge
Fuel Gauge
Fuel Cap
Power Cord
Fuel Tank
Power/Reset Switch
Thermostat Knob
Lamp
Lower Shell
Upper Shell
Power
Cord
Drain Bolt
Fuel Tank
Pressure
Gauge
Fan Guard
Rear Handle
Digital Temperature
Display
Lamp
Thermostat
Knob
Fuel Cap
Fuel Gauge
Lower Shell
Hot Air
Outlet
Front
Handle
1.
Insert axle through holes in wheel support.
2.
Slide spacer onto axle.
3.
Slide wheel onto axle and hold in place with the axle
nuts (see Figure 1).
4.
Place heater on wheel support and line up holes on the
fuel tank lip.
5.
Attach front handle with (2) long screws (50 mm) and
(2) nuts through the second hole from the front on
both sides of the tank lip and wheel support frame and
tighten firmly.
6.
Insert (2) short screws (30 mm) through the first hole
from the front in the tank lip and tighten firmly. Make
certain all (4) screws are secure.
7.
Attach rear handle with (2) long screws
(50 mm) and (2) nuts through the second hole from the
rear of the heater on either side (see Figure 2).
8.
Tilt the heater up gently so it is resting on the front
handle.
NOTE:
DO NOT do this if there is fuel in the tank.
9.
Remove the wheels to secure the second set of screws
through the rear handle.
10. Secure the rear handle with (2) short screws (30 mm)
and (2) nuts and tighten firmly.
11. Replace wheels and tighten with the wheel nuts.
12. Tilt heater back down onto wheels and check all screws
and nuts to ensure they are secure.
Figure 1
Axle
Axle Nut
Spacer
Tire
Wheel Support Frame
Figure 2
