16 ► GT18B01-B02
User Manual
1
APECS unit not calibrated
yes
Have engine serviced by an Authorized Stanley Dealer.
2
Engine speed excessive
yes
Have engine serviced by an Authorized Stanley Dealer.
3
Engine speed unusually low
yes
Have engine serviced by an Authorized Stanley Dealer.
4
Engine shutdown due to engine
protection input
yes
Have engine serviced by an Authorized Stanley Dealer.
5
Factory settings lost
yes
Have engine serviced by an Authorized Stanley Dealer.
6
External pot out-of-range
no
Have engine serviced by an Authorized Stanley Dealer.
7
Accelerator position / idle
switch conflict
no
Have engine serviced by an Authorized Stanley Dealer.
8
Controller unit failed
yes
Have engine serviced by an Authorized Stanley Dealer.
9
Limiting excessive
actuator current
no
Have engine serviced by an Authorized Stanley Dealer.
10
Engine speed input
signal missing
no
(Active only in Auto crank mode).
Check speed sensor wiring.
Check starter motor.
11
Auto crank unable to
start engine
no
Check fuel.
12
Auxiliary output is shorted
no
Check the lamp or relay hooked to the output. If fault is
still present, have engine serviced by an authorized
Stanley Dealer.
13
Auxiliary output #2 is shorted
no
Check the lamp or relay hooked to the output. If fault is
still present, have engine serviced by an authorized
Stanley dealer.
14
Actuator disconnected or
open circuit
no
Check actuator wiring and actuator resistance.
Resistance should be less than 10 ohms.
FLASH
ENGINE
CODE
FAULT
SHUTDOWN
CORRECTIVE ACTION
FAULT CODES
