21
FAULT FINDING
If the stove exhibits any of the following conditions, call your Commissioning Engineer.
PROBLEM
CAUSE
REMEDY
Stove will not light or goes
No Oil in the Tank
Fill Tank
out when lighting
Fire Valves off
Reset valves, check for
cause of over temperature
Control valve trigger down (off)
Reset trigger
Oil feed line filter blocked
Free Oil filter
Fuel Line Air Locked
Bleed Fuel Line
Carbon Leg Blocked
Clean Carbon Leg Assembly
(Stove needs service)
Incorrect Depth of Oil in Burner
Increase oil level to 4mm
Base
Down Draught in Flue
Fit Anti-Down Draught Cowl
Flames burning under burner
Incorrect Chimney Draught
Check joint seals, increase
chimney height, adjust flue
bonnet spin valve.
Down Draught in Flue
Fit Anti-Down Draught Cowl
Oil level too high in burner base
Decrease oil level to 4mm
Oil Rate too high
Lower control valve fuel input
rate
Dirty or Unstable Flame, Viewing
Incorrect Chimney Draught
Check joint seals, increase
Glass sooting up
Chimney height, adjust flue
bonnet spin valve.
Incorrect Fuel Input Rate
Check Fuel Input Rate, adjust
if necessary
Incorrect Spin Valve Setting
Adjust Spin Valve Setting
Shells or Vapour Chamber Lid
Ensure all shells are seated
not seated properly
on Burner base and that their
seams are staggered.
Lighting Port Open
Close Lighting Port
Wrong Grade of Oil Used
Only Use Kerosene 28 sec C2
Wicks incorrectly Positioned
Ensure that the cut-outs in the
wicks are properly aligned
and that the shells don’t
interfere with the wicks
Oil Smell Apparent
Incorrect Chimney Draught
Check joint seals, increase
chimney height, adjust the
bonnet spin valve.
Down Draught in Flue
Fit Anti-Down Draught Cowl
Incorrect Fuel Input Rate
Check fuel input rate, adjust if
necessary
Fuel Leaks
Check all fuel pipe connec-
tions, and reseal if necessary.
Cooker Overheating
Incorrect Fuel Input Rate
Decrease Fuel Input Rate