Stanley AV 10, Assembly Instructions Manual

Page: 10 / 20

PROSET XT3 & XT4 NOSE ASSEMBLIES – 71220-16100, 71230-15800 & 71230-16100
IMPORTANT
Read the safety warnings listed in the ProSet
®
XT3 and ProSet
®
XT4 Instruction Manual carefully before putting
into service.
IMPORTANT
The air supply must be turned off or disconnected before fitting or removing the nose assembly.
Part Number: 71220-16100
Item Part Number Description Qty
1 07340-00306 Nose Casing 1
2 07003-00067 O Ring 1
3 07612-02003 Jaw Housing 1
4 71220-16120 Jaws (3 pcs) 1 Set
5 07498-04502 Jaw Spreader 1
6 07498-03003 Buffer 1
7 07500-00418 Jaw Pusher Spring 1
8 07340-00327 Locking Ring 1
Part Number: 71230-16100
Item Part Number Description Qty
1 07340-00306 Nose Casing 1
2 07003-00067 O Ring 1
3 07612-02003 Jaw Housing 1
4 71230-16101 Jaws (3 pcs) 1 Set
5 07498-04502 Jaw Spreader 1
6 07498-03003 Buffer 1
7 07500-00418 Jaw Pusher Spring 1
8 07340-00327 Locking Ring 1
Part Number: 71230-15800
Item Part Number Description Qty
1 07340-00306 Nose Casing 1
2 07003-00067 O Ring 1
3 07612-02003 Jaw Housing 1
4 07612-02002 Jaws (3 pcs) 1 Set
5 07498-04502 Jaw Spreader 1
6 07498-03003 Buffer 1
7 07500-00418 Jaw Pusher Spring 1
8 07340-00327 Locking Ring 1
FITTING INSTRUCTIONS
Item numbers in
bold
refer to nose assembly components in the tables and diagram above.
• The air supply must be disconnected.
• If necessary, remove the complete nose assembly 76003-15000 as described in the ProSet
®
XT3 and ProSet
®
XT4
instruction manual.
• Fit the XT3 Adapter Kit 76003-20400 to the tool piston and then tighten the locknut (71210-02103) against it using
spanners.
• Lightly coat Jaws (
4
) with Moly Lithium grease*.
• Drop Jaws (
4
) into Jaw Housing (
3
).
• Insert Jaw Spreader (
5
) into Jaw Housing (
3
).
• Locate Buffer (
6
) on Jaw Spreader (
5
).
• Locate Spring (
7
) onto Jaw Spreader (
5
).
• Fit Locking Ring (
8
) onto the jaw spreader housing from XT3 Adapter Kit 76003-20400.
• Holding tool pointing down, screw the assembled jaw housing onto the jaw spreader housing and tighten with
spanner.
• Screw the nose tip into Nose Casing (
1
) and tighten with spanner.
• Place Nose Casing (
1
) with O Ring (
2
) over Jaw Housing (
3
) and screw onto the tool, tightening with spanner.
10
ENGLISH ORIGINAL INSTRUC TION