Stanley 76501-02000, Manual

Page: 7 / 85

6
•
Whipping hoses can cause severe injury. Always check for damaged or loose hoses and fittings.
•
Prior to use, inspect hydraulic hoses for damage, all hydraulic connections must be clean, fully engaged and tight
before operation. Do not drop heavy objects on hoses. A sharp impact may cause internal damage and lead to
premature hose failure.
•
Whenever universal twist couplings (claw couplings) are used, lock pins shall be installed and whipcheck safety
cables shall be used to safeguard against possible hose-to-tool or hose-to-hose connection failure.
•
DO NOT lift the placing tool by the hose or electrical cable. Always use the placing tool handle.
•
DO NOT pull or move the hydraulic pump unit using the hoses. Always use the pump unit handle or roll cage.
•
Keep dirt and foreign matter out of the hydraulic system of the tool as this will cause the tool to malfunction.
•
Use only clean oil and filling equipment.
•
Only recommended hydraulic fluids may be used.
•
Power units require a free flow of air for cooling purposes and should therefore be positioned in a well ventilated
area free from hazardous fumes.
•
Maximum temperature of the hydraulic fluid at the inlet is 110°C (230°F).
STANLEY Engineered Fastening policy is one of continuous product development and
improvement and we reserve the right to change the specification of any product without prior
notice.