Stanley 76501-02000, Manual

Page: 19 / 85

18
LCD Menus
•
The software provides the operator with the following Menus:
•
RET TIME – This screen allows the operator to set the value of the Return Timer. This timer controls the time that the
pump motor will continue to run, after releasing t he trigger or achieving the ‘High Press ure ’ value, before switching to
the idle mode. Set the timer between 5 and 20 seconds by pressing the Down or Up Arrow buttons. The time will change
in increments of 1 second. Save the setting and step forward using the MENU button.
SCREEN 2
SET
5
SEC
RET TIME
•
UNITS – This screen allows the operator to set the units of pressure-measurement that are displayed on the screen
during operation of the pump. Set the pressure units to PSI / MPa / BAR by pressing the Down or Up Arrow buttons. BAR
is the default setting. Save the setting and step forward using the MENU button.
SCREEN 3
SET
PSI
BAR
MPa
UNITS
•
AUTOMODE ON – (Not shown) This screen indicates that the pump is set to operate in ‘Automode’ , whereby the preset
‘High Pressure’ va lue controls the point at which solenoid valve will automatically de-energise and reverse the flow of
pressurised oil to the return side of the placing tool. This function is locked and cannot be changed.
•
HI PRESS – This screen allows the operator to set the maximum pull pressure to which the placing tool will operate and
auto-return. Set the high pressure value by pressing the Down or Up Arrow buttons. The pressure will change in
increments of 10 bar. Save the setting and step forward using the MENU button
.
SCREEN 5
SET
510
BAR
HI PRESS