Stamina 85-2221A, Owner'S Manual

Page: 16 / 26

a. Use the LEVER(55) to adjust the UPRIGHT(3) backward to Position 5.
b. Remove the
BALL PIN(49)
from the
REAR FRAME(2).
Fold the
REAR FRAME(2)
close to the
MAIN
FRAME(1) and lock it in folded position with the BALL PIN(49). Fold the BACK CUSHION(40) flat.
NOTE:
STORAGE
16
B A
Make sure the BALL PIN(49) goes through the holes on both sides of the REAR FRAME(2)
and the tube on the
MAIN FRAME(1).
The safety and integrity designed into the Wirk
TM
Ride Workstation can only be maintained when the
Wirk TM Ride Workstation
is regularly examined for damage and wear. Special attention should be given
to the following:
1. Adjust the
TENSION KNOB(57)
and verify that it functions properly and the resistance changes.
2. Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that
the left pedal has left hand threads and is tightened by turning counterclockwise.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
4. Verify that the CAUTION LABEL(103) is in place and easy to read. Call Stamina Products
immediately at 1-800-375-7520 for a replacement CAUTION LABEL(103) if it is missing or damaged.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components shall be replaced immediately or the Wirk TM Ride Workstation
removed from service until repair is made.
7. Only Stamina Products supplied components shall be used to maintain/repair the Wirk
TM
Ride
Workstation.
8. Keep your Wirk
TM
Ride Workstation clean by wiping it off with an absorbent cloth after use.
MAINTENANCE
1. Remove all items from the DESKTOP(21) before moving or folding the Wirk
TM
Ride Workstation.
2. To store the
Wirk TM Ride Workstation,
simply keep it in a clean dry place.
3. To avoid damage to the electronics, remove the batteries before storing the Wirk
TM
Ride Workstation
for one year or more.
4. To move the
Wirk TM Ride Workstation,
hold the
HANDRAIL(8)
and tilt the
Wirk TM Ride Workstation
onto the WHEELS(32) of the REAR STABILIZER(10).
5. The minimum folded dimensions of the Wirk
TM
Ride Workstation are approximately 31.8 inches
long x 21.7 inches wide x 40.4 inches tall. Please measure your
Wirk TM Ride Workstation
if exact
dimensions are needed.