4 feet
6 feet
Place the
Wirk
TM
Ride Workstation
in the area where it will be used. It is recommended that the
Wirk
TM
Ride Workstation
be placed on an equipment mat. The
Wirk
TM
Ride Workstation
is approximately 45
inches long x 21.7 inches wide x 45.7 inches tall. (These dimensions may vary up to one inch.) An area
4 feet wide x 6 feet long is required for safe operation of the
Wirk
TM
Ride Workstation.
Make sure that
adequate space is available for access to and passage around the
Wirk
TM
Ride Workstation.
LEVELING:
Adjust the
LEVELING CAPS(31)
on the
REAR STABILIZER(10)
so that the
Wirk
TM
Ride
Workstation
sits on the floor without rocking.
MOVING:
The
Wirk
TM
Ride Workstation
has a pair of
WHEELS(32)
on the
REAR STABILIZER(10).
Hold the
HANDRAIL(8)
and tilt back on
WHEELS(32)
to move the
Wirk
TM
Ride
Workstation.
FUNCTION INSPECTION:
Visually inspect the
Wirk
TM
Ride Workstation
to verify that assembly is as shown in the above
illustration. Check the function of the
Wirk
TM
Ride Workstation
by turning the crank slowly through one
complete revolution to verify that the drive train functions properly. Adjust the
TENSION KNOB(57)
and
verify that it functions properly and the resistance changes.
CAUTION:
Locate and read the
CAUTION LABEL(103)
on the
WirkTM Ride Workstation.
Make sure
that all users read the
CAUTION LABEL(103)
before using the product.
SET UP INSTRUCTIONS
11
Equipment Mat
(not included)
Summary of Contents for 85-2221A
Page 3: ......
Page 20: ...PRODUCT PARTS DRAWING 20 FRONT BACK...
Page 24: ...NOTES 24...
Page 25: ...NOTES 25...
