Stamina 85-2221A, Owner'S Manual

Page: 13 / 26

WEIGHT LIMITATIONS
WARNING: Serious injuries can occur from Wirk
TM
Ride Workstation tip-over. To help prevent tip-over:
Do not exceed listed weight limits
Never allow children to climb or hang on the Wirk TM Ride Workstation
Do not lean on the desktop in any direction
OPERATIONAL INSTRUCTIONS
SEAT ADJUSTMENT
1. Turn the ADJUSTMENT KNOB(36) to loosen, then pull
the
ADJUSTMENT KNOB(36)
to release the pin. Slide the
SEAT POST(6) until the SEAT(39) is at the proper height.
Release the ADJUSTMENT KNOB(36) making sure the
pin catches in one of the holes of the
SEAT POST(6)
and
tighten the ADJUSTMENT KNOB(36).
Proper seat adjustment is important.
1. Do not attempt to adjust the seat while you are
on the
Wirk
TM
Ride Workstation.
2. Always tighten the ADJUSTMENT KNOB(36)
after adjusting the seat to a new position.
To increase the load, turn the TENSION KNOB(57) clockwise.
To decrease the load, turn the TENSION KNOB(57) counterclockwise.
LOAD ADJUSTMENT
2. Sit on the seat and place your feet on the pedals. You should
be able to move through a complete pedal stroke without
locking your knees or shifting your hips on the seat. The seat
is too close to the pedals if you have more than a slight bend
in your knees at the bottom of the pedal stroke. The seat is
too far from the pedals if you have to completely straighten
your knees at the bottom of the pedal stroke. Refer to the
illustration.
CAUTION:
13