ASSEMBLY INSTRUCTIONS
STEP 5:
Insert the
UPRIGHT(6)
into the
LOW UPRIGHT(12)
and secure with
BUTTON HEAD BOLTS
(M8x1.25x16mm)(10)
and
ARC WASHERS(M8)(11).
STEP 6:
Insert the
HANDLEBAR POST(59)
into the
UPRIGHT(6),
and lock it in one of the adjustment
holes with
ADJUSTMENT KNOB(3).
NOTE:
There are three adjustment holes on the
HANDLEBAR POST(59)
for adjusting the height of the
HANDLEBAR(5).
STEP 7:
Refer to the detail view A.
Note the correct position of the
HANDLEBAR(5),
the
HANDLEBAR(5)
should be assembled with a 27.5 degree angle forward from the
HANDLEBAR
POST(59).
Attach the
HANDLEBAR(5)
to the
HANDLEBAR POST(59)
with
HEX BOLTS(M6x1x33mm)
(80), ARC WASHERS (M6)(81),
and
NYLOCK NUTS(M6x1)(14).
The
HEX BOLTS(M6x1x33mm)(80)
fit
inside the hex-shaped holes in the
HANDLEBAR POST(59).
STEP 8:
Find the two cavities on either side of the meter case, grasp the
METER(24)
and pull it out
from the
COVERS(77, 78)
being careful not to disconnect or damage the
SENSOR WIRE(30).
Install
two AAA batteries into the
METER(24)
,
the batteries are not included. See page 11 for detailed battery
installation instructions. Push the
METER(24)
back into position.
9
hex-shaped
hole
A.
Cavity
