127303 / 8003607300
2016-05-23·BA00·III·en·05
Mounting and Installation
11
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Panel mounting devices
Series 8003/1
7.2
Mounting / Dismounting, Operating Position
7.2.1 Operating Position
The devices are suitable for installation on enclosure walls or panels with a wall thickness
of 1.0 to 6.5 mm. The mounting hole diameter is 30.5 mm.
7.2.2 Assembly
Single hole mounting
11610E00
• Push the actuator (1) into the
installation wall (2) and lock it
into position. Ensure that the
seal (4) is seated precisely
when doing so.
• Push the panel mounting
device (3) onto the actuator (1)
from the back of the installation
wall. Observe the position of
the snap fit when doing so.
• Tighten the actuator (1) against
the installation wall (2) to
which it is fitted by turning
the threaded nut (8).
(Tightening torque of the
threaded nut: 2.5 Nm)
• Ensure that the panel mounting
device (3) and the actuator (1)
are firmly attached in the
installation wall (2).
Legend
1 = Actuator
5 = Rib
2 = Installation wall
6 = Groove
3 = Panel mounting device
7 = Cable gland
4 = Seal
8 = Threaded nut
NOTICE
Malfunction of the device due to improper mounting of the key-operated switches
8003/1..-008 and the rotary actuators 8003/1..-726 and -727.
Non-compliance may lead to material damage!
• Fit the rib (5) exactly into the groove (6) of the installation wall (2).
• Insert the panel mounting device (3) in such a way that the cable gland (7) is
rotated by 180° relative to the groove (see single hole mounting figure:
groove at the top, cable gland downward).
(4)
(5)
(6)
(2)
(8)
(7)
(3)
(1)
