14
Remote Control Operation ...............................................................
For best result, use VT-1 wired controller.
The LED screen of the
haze
shows as left picture;
Press again Timer to stop Timing fogging, red dot
disappears at the same time;
After the end of the pipe clearing, Standby will appear.
When the machine stops fogging, please do not unplug
the machine immediately, but wait 100 seconds to let
the machine automatically clean the fluid left in the
pipe. This is to avoid causing negative effect when used
next time. The LED screen will show as the picture, and
letters are slow flashing;
The LED screen of the
haze
shows the increase and decrease
correspondingly with adjusted by controller, the red dot will
run circularly;
When the machine stops fogging, please do not unplug
the machine immediately, but wait 100 seconds to let
the machine automatically clean the fluid left in the
pipe. This is to avoid causing negative effect when used
next time. The LED screen will show as the picture, and
letters are slow flashing;
After the end of the pipe clearing, Standby will appear.
1.
Firmly attach the remote control mechanism to socket (Figure1-J) on the
back of the unit;
2.
Plug mains power cord from the machine into appropriate power supply
socket, the red LED upon the controller is lighted;
3.
The volume adjustment knob on the controller is with the switch;
6.
The volume adjustment knob clockwise adjustment volume increases,
counterclockwise adjustment volume reduction, the green LED upon the
controller is blinking;
4.
Turn the knob counterclockwise to the end to switch off, the fog is off,
the green LED upon the controller is lighted;
5.
5.
7.
9.
9.
8.
8.
s t b y
s t b y
pI C L
pI C L
0 0 0
0 . 0 7
0 0 2
