13
Continuous Fogging Operation .......................................................
Panel control, DMX signal is not connected.
Timing Fogging Operation ...............................................................
Panel control, DMX signal is not connected.
Press MENU to enter Volume adjustment, the picture
shows the new machine default state;
Press MENU to enter to Interval;
Press “Up” or “Down” to adjust the value of interval
(20s-900s), the picture shows the Interval value is 668s;
Press again MENU to switch to adjust the value of duration,
please note timing fogging still stops at the same moment;
Press “Up” or “Down” to adjust time value of duration
(10s - 200s), the picture shows the Interval value is 58s;
Press “Up” or “Down” to adjust smoke volume value
(1 -100%), the picture shows the volume value is 20%;
Press Manual Fog to starts continuous fogging status,
the red dot will run circularly;
After setting the interval and duration, press Timer to
start timing fogging, the display will shows decreasing in
duration, and then shows decreasing in interval, continuous
repeating cycle, the red dot will run circularly;
Press Manual Fog again to stops continuous fogging
status, the red dot disappears at the same time;
After the end of the pipe clearing, Standby will appear.
When the machine stops fogging, please do not unplug
the machine immediately, but wait 100 seconds to let
the machine automatically clean the fluid left in the
pipe. This is to avoid causing negative effect when used
next time. The LED screen will show as the picture, and
letters are slow flashing;
1.
1.
2.
3.
5.
And so on, you could also adjust the volume;
4.
2.
3.
6.
4.
6.
5.
U 1 0 0
L 0 2 0
L 6 6 8
U 0 2 0
U 0 2 0
s t b y
pI C L
0 . 2 0
0 5 5 .
0 1 2
0 5 8
