INSTALLATION AND USER MANUAL
200TDHW
18
V0REV1EN0218
11.9.
O FF - P E A K
This mode is only available when the 200TDHW has been correctly installed and connected in Off-
peak (or Night tariff) configuration. In this configuration Program mode is not applicable and it is
automatically disabled.
The off-peak detection can be activated/ deactivated by a long press on “OK” buttons or by set “I3”
parameters at 1 (See INSTALLER MENU chapter).
symbol indicates that the water heater is in Off-peak configuration. When
is blinking, an off-
peak period or night tariff period is currently detected.
11.10.
Reset
To reset error indication, long press simultaneously on
and keys.
To reset Program setting, while in program mode, long press simultaneously on
and
keys.
11.11.
Anti short cycle
T
o optimize the life time of your heat pump, 200TDHW implement an anti-short cycle mechanism. As
a consequence, the compressor of the heat pump may start working after a shot delay. When Anti
short cycle process is activated, the Heat pump symbols are blinking until the compressor starts
operation.
USER MANUAL
ECOHEAT TD CONTROLLER
9
I
9.
O F F - P E A K
This mode is only available when the ECOHEAT has been correctly installed and connected in
Off-peak (or Night tariff) configuration. In this configuration Program mode is not applicable and it is
automatically disabled.
The off-peak detection can be activated/ deactivated by a long press on “OK” buttons or by set “I3”
parameters at 1 (See INSTALLER MENU chapter).
symbol indicates that the water heater is in Off-peak configuration. When is blinking, an off-
peak period or night tariff period is currently detected.
10.
RESET
To reset error indication, long press simultaneously on and
keys
To reset Program setting, while in program mode, long press simultaneously on
and keys
11.
ANTI SHORT CYCLE
To optimize the life time of your heat pump, ECOHEAT implement an anti-short cycle
mechanism. As a consequence, the compressor of the heat pump may start working after a shot delay.
When Anti short cycle process is activated, the Heat pump symbols are blinking until the compressor
starts operation.
USER MANUAL
ECOHEAT TD CONTROLLER
9
I
9.
O F F - P E A K
This mode is only available when the ECOHEAT has been correctly installed and connected in
Off-peak (or Night tariff) configuration. In this configuration Program mode is not applicable and it is
automatically disabled.
The off-peak detection can be activated/ deactivated by a long press on “OK” buttons or by set “I3”
parameters at 1 (See INSTALLER MENU chapter).
symbol indicates that the water heater is in Off-peak configuration. When is blinking, an off-
peak period or night tariff period is currently detected.
10.
RESET
To reset error indication, long press simultaneously on and
keys
To reset Program setting, while in program mode, long press simultaneously on
and keys
11.
ANTI SHORT CYCLE
To optimize the life time of your heat pump, ECOHEAT implement an anti-short cycle
mechanism. As a consequence, the compressor of the heat pump may start working after a shot delay.
When Anti short cycle process is activated, the Heat pump symbols are blinking until the compressor
starts operation.
L
a
p
