P a g e |
24
P a g e |
PROBLEM:
POSSIBLE CAUSE:
SOLUTION:
Power Switch
is turned “ON”,
cycle does not
work
Battery not installed or fully seated
Verify a fully charged battery is installed
until battery release button “clicks”
Verify the battery is fully charged
Verify the fuse is good and properly
installed. Look for water damage. Replace
the fuse with the correct amperage fuse
Battery not fully charged
Fuse not installed or burnt-out
height is achieved, then tighten the adjustment clamp. The seat post is marked with
anindicator line. Do not extend past the indicator line.
Note: Low seat height is recommended. Low seat height allows the operator to easily reach the
ground for more secure footing, and increases rider confidence.
Battery and Battery Disposal:
Refer to battery manufacturer documentation for proper battery maintenance.
Battery Disposal: Your cycle uses sealed lithium cell batteries which must be recycled or
disposed of in an environmentally safe manner. Do not dispose of a lithium cell battery in a
fire; the battery may explode or leak. Do not dispose of a lithium cell battery in your regular
household trash. The incineration, land filling or mixing of sealed lithium cell batteries with
household trash is prohibited by law in most areas. Return exhausted batteries to a federal or
state approved lithium cell battery recyclers or a local seller of batteries. Many states have laws
prohibiting the disposal of lithium cell batteries in the municipal waste stream. Check with
your local state law.
Wheels/Tires:
Wheels and tires are subject to normal wear and tear. It is the responsibility of the user and
parent to periodically inspect wheels and tires for damage and excessive tread wear. Do not
operate with worn or damaged tires.
TROUBLESHOOTING GUIDE
A fully charged battery must be installed prior to performing any troubleshooting and must
ONLY be performed by an adult.
ERROR CODES
POWER
SWITCH
THROTTLE
POSITION
SITUATION/ REACTION
LED
ON
ON
ZERO TO
FULL
ZERO TO
FULL
Flashing
YELLOW
Flashing
RED
ESC overload error, reset by turning POWER SWITCH
“OFF”, then back “ON”
Temperature error, reset by turning POWER SWITCH
“OFF, then back “ON”; change riding conditions and
ride on flat ground to cool down cycle
