STACKER 500KS USER GUIDE 31
rehoming the Zaxis (decreasing layer height). Each full rotation will adjust the layer height by
0.75mm.
It’s much better to start your first print with a higher first layer height to prevent your bed from
contacting the nozzles. Simply readjust and rehome the bed until the first layer height is spot on.
Use test prints to help you accomplish this. Be sure your bed is level before you begin.
If your print quality is less than desired, please take a look at the Simplify3D print quality
troubleshooting guide. It provides excellent visuals of common problems and solutions.
● https://www.simplify3d.com/support/printqualitytroubleshooting/
5.9. Multipart Print Mode
With STACKER’s multipart print mode, each extruder can print a copy of the same object. You can
print up to four copies in the same time it would take to print one! With multipart printing, you can
print 2, 3, or 4 COPIES at once.
Set Extrusion Mode
In order to print multiple copies of the same object, you need to turn on multipart print mode by
clicking on the “Extruder Setup” button. Be absolutely sure all hot ends are turned off before you
