STACKER 500KS USER GUIDE 15
VIDEO ALERT!
Please watch the short video “Bed Leveling” located on our Kickstarter Video
Support Page.
●
http://stacker3d.com/kickstartervideopage/
FULL ADJUSTMENT PROCESS
Step 1. Connect your printer to STACKER RUN software
. Click the Connect button located in
the upper left corner. A drop down menu will allow you to select the correct model, as shown by the
arrow.
Step 2.
Home the Z axis on the aluminum setup block.
Place the aluminum setup block under the zprobe adjustment screw BEFORE homing the zaxis,
as shown below.
Next, open the Manual Control Tab and press the Zhome button
in
STACKER RUN
.
NOTE: You must use the setup block under the zprobe as shown above.
If you do not use
the block, you could crash your bed into the nozzles and cause damage to your printer
.
