STACK Dash-2 Kart Logger
Error! Main Document Only.5. Installing the Dash-2 Kart Logger
Users Guide
33
Fitting the Steering Position Sensor
The steering position sensor takes the form of a rotary potentiometer mounted in a bracket clamp and is supplied with an additional L
bracket to allow unit attachment to the kart by means of the steering column support bracket bolt.
Procedure
1.
Assemble the sensor bracket so that it looks like the
one in the picture. Ensure that the pulley wheel is
secure on the sensor spindle. Ensure the pulley does
not foul on any part of the sensor bracket
2.
Remove the steering wheel and the steering column
support. Make a double loop around the steering
column with the long O ring supplied..
3.
Re-attach the steering column and steering wheel.
1.
Fit the sensor L bracket by means of the Steering
column support bolt, using one of the 4 available
attachment holes.
When you have decided on the correct holes for your
kart, you can cut the unused portion off.
1.
Loop the long end of the O ring fitted to the steering
column around the pulley wheel and bring the O ring
under tension by angling the L bracket downwards.
Insufficient O ring tension will allow it to slip on the
steering column, producing incorrect
sensor data.
If you wish to shorten the O ring, then cut it
with a sharp knife and rejoin it using
superglue.
2.
Once the sensor is installed, connect the
sure seal connector to the system harness
input labelled SP.
