STACK Dash-2 Kart Logger
Error! Main Document Only.5. Installing the Dash-2 Kart Logger
Users Guide
27
1.
Using the screws and rubber washers supplied, attach the Dash-2 to
the Nassau panel.
2.
Lastly, centralise the unit so that it is in line with the steering wheel
and then tighten the two locknuts holding it to the bottom brackets.
Wiring
The Display, sensors and switches for your System are connected
together by means of the wiring supplied with the system.
This wiring has been designed so that the various branches are long
enough for most Karts. Provided that you have chosen suitable locations
for the sensors that you are installing, you should not need to extend any
of the individual wires.
Fitting the wiring
When fitting the sensors on the kart, you should observe the following:
•
All wires should be as far as possible, and not less than 50mm, from ignition HT leads and distributor caps, etc.
•
When you pass any wire through a panel, fit a cable gland into the hole so that the edge of the hole cannot chafe the
wire.
•
Particular care is needed when passing wires through holes in carbon fibre, as the carbon can cut through cables very
easily.
Electrical Interference
IMPORTANT The kart must have a suppressed ignition system for the Dash-2 to operate correctly and reliably. Solid core leads with a
5k suppressed plug cap or silicone suppressed HT leads are appropriate.
