Maintenance and repairs
As all sports equipment, maintenance and repairs is important for optimal performance over
long time and usage. Various replacements parts can be purchased from our homepage at
www.staaker.com
.
After flight
For a longer life we recommend to always:
-
Rinse the tracker in fresh water if it has been exposed to water. Especially important
after use in salt water to prevent corrosion on the USB port. Be careful to dry off the
tracker after rinsing, especially the USB port.
-
Use the casing when transporting.
-
Charge the batteries after usage and do not store an empty or full battery for longer
periods.
-
Change propellers if damaged.
-
Check for damages after hard landings.
-
Always use the rubber USB protector on the tracker.
Warranty warning
⚠
We recommend that all repairs is done by personnel authorized by Staaker, if this
is done by unauthorized personnel it will affect the warranty of the product. See “Terms
& Warranties”.
Replacing arms
1. Place the drone upside down, unfolded, on a table.
2. Loosen all set screw on all four legs.
3. Unscrew all four socket head cap screws for the legs and remove them.
4. Unscrew all torx on the bottom part of the main body.
5. Lift up the bottom part a few cm and unplug the LED.
6. Unplug the gimbal power and the gimbal signal cable.
7. Unplug the connectors for the motor and change the arm. Remember to match the
colors of the connectors when replacing the new one.
8. Assembly by doing point 1-6 in reverse.
⚠
Ensure that no cables get squeezed when reassembling.
42
