EN - 19
13. MAINTENANCE TABLE
Intervention
Frequency
Notes
MACHINE
Check the status of the connection
cable of the battery backpack.
Before each use.
-
Check all fasteners.
Before each use.
para. 7.4
Safety checks/command check.
Before each use.
para. 6.2
Check the cutting means guard.
Before each use.
par. 6.2.1
Check the cutting means.
Before each use.
par. 6.2.1
Check the battery charge status.
Before each use.
*
Recharge the battery.
After each use.
para. 7.2.2
*
Clean the machine and the engine.
After each use.
para. 7.3
Checking for any damage to the machine. If
necessary, contact the authorised service centre.
After each use.
-
* Refer to the battery/battery charger manual.
14. TROUBLESHOOTING
PROBLEM
PROBABLE CAUSE
SOLUTION
1.
The motor shuts down
whilst working.
The connection cable is not correctly
inserted in the battery backpack.
Check the correct connection of the cable to
the machine and to the battery backpack.
Battery is not inserted correctly.
Make sure that the battery is correctly
inserted in the battery backpack (par. 7.2.3).
Low battery.
Check the charge status and
recharge the battery (par. 7.2.2), or, if
available, choose another battery.
Machine damaged.
Do not use the machine. Disconnect the
machine from the battery backpack and
contact an Authorised Service Centre.
2.
The cutting means
does not rotate even
if the throttle control
lever (Fig. 11.A) and
throttle safety button
(Fig. 11.B) are engaged.
Battery is not inserted or is
inserted incorrectly.
Make sure that the battery is
inserted correctly (par. 7.2.3).
Incorrect connection to the
battery backpack.
Check that the machine is correctly
connected to the battery backpack.
Low battery.
Check the battery status and
recharge if necessary (par. 7.2.2).
Battery backpack selector to "OFF".
Check that the selector (Fig. 10.B)
is placed on one of the batteries
inside the battery backpack.
The throttle control lever is faulty
or the machine is damaged.
Do not use the machine. Stop the
machine immediately, disconnect it
from the battery backpack and contact
an Authorised Service Centre.
3.
Engine overheating.
Grass trapped under the
cutting means guard.
Remove trapped grass (par. 6.5).
4.
Mowing is difficult.
The cutting means is not
in good condition.
Proceed with the cutting means
maintenance (par. 8.1).
If problems persist after having performed the operations described above, contact your dealer.
Summary of Contents for BC 900 D Li 48
